Ride On Extender Silicone Male Strap-on
GO TO SHOPPING SITE

Ride On Extender Silicone Male Strap-on

The Vixen Extenders Male Strap-on are hollow silicone dills with a stabilizing ring attached to the base. They are intended to be used by people with ED or simply to add girth and length to what you’ve already got!

These Male Strap-on Extenders are made of Vixen Creations’ excellent medical grade silicone, in order to function well, they must fit closely. (See the “internal” measurements below!) Just a word of caution, they do not stretch very much, so choose the size that fits you best.

We love the design of the cock ring at the base of the toy. It’s stretchy enough to be functional, but wide and sturdy enough to provide support while it’s being used, um, rigorously. There are special instructions from the manufacturer on how to best put the extender on, so do check out our “specifications” tab below!

WARRANTY: Lifetime warranty against manufacturing defects.

DIMENSIONS: Outer: 6-¼” x 1-¾” Inner: 4″ x 1″

More on How To Choose

MORE ON HOW TO CHOOSE: DILDOS

Generic Care Information

GENERIC CARE INSTRUCTIONS: SILICONE CARE

Owner's Manual

SPECIAL INSTRUCTIONS: Not compatible with silicone lubricants.

HOW TO BEST PUT ON THE RIDE ON: (from Vixen Toys)
This instruction guide is the best way, with or without an erection to secure the Ride On. The basic philosophy is to create a vacuum and pull the penis into the Ride On rather than to push. This is best accomplished by rolling the sleeve inside out about one third the way down the shaft. You will see a gripping ridge designed to help stability. Use approximately a quarter’s diameter size amount of water-based lubricant divided between the inside of the Ride On and your penis. Too much lubricant will eliminate the friction that helps your penis and the Ride On move as one. We recommend you practice putting it on at least once, before trying with a partner. This will allow you to fine tune the procedure.
With one hand squeeze the Ride On, eliminating the air inside. With your other hand, push the head of the penis into the opening and slowly release the pressure on the Ride On from the bottom up. This is accomplished by releasing the pinkie, then ring finger, middle finger then pointer. The action will pull your penis into place. Unroll the sleeve to the base of your body.
Take the testicle ring and pull your scrotum through the ring as far as possible where the testicles touch the Ride On but are not through. Then pull the ring with your left hand to the left and push through that testicle. Repeat on the other side.
If your penis is not firmly held when using, reduce the amount of lubricant on the inside. Once you start to use the Ride On with a partner, use plenty of lube on the outside. This will make it more comfortable for your partner and also reduce the chance of internal slippage of your penis.

QUICK GUIDE
-Roll the sleeve one third of the way down.
-Apply lubricant to the inside of the Ride On and your penis.
-Squeeze out the air.
-Place your penis into the opening and gradually release the pressure.
-Unroll the Ride On to the base.
-Pull the scrotum through the hole.
-Pull to one side and push through one testicle.
-Repeat with the other.
-Have fun!