Feeldoe Double Ended Dildo
In fact, once the bulb end is inserted, the angle of the toy is much more akin to an erection (up and flatter to the body) than the right angle of the toy to the body that is the norm with dill and harness setups. Great for the missionary position. The aspect used by the penetrator (“thrust controller”) has a thicker bulb with a narrow neck. This shape allows the walls of the vagina to grip the toy and draw it in making for a lot of movement before the thrusting even starts.
The elbow joint on the Feeldoe Double Ended Dildo has an extra mass that fits nicely in the crook of the crotch contributing to a secure hold when used without a harness. The elbow’s base even has a groove into which you can settle the strap of a G-string harness. The shaft has a few ridges that may hit the clit of the harness wearer but you won’t be disappointed if they don’t reach. Comes with a vibe but we don’t consider it a selling point. Vibe runs on 3 LR44 button cell batteries (included) so pick up an extra set. For more power, consider replacing with the rumbly We-Vibe Tango!
WARRANTY: 1-year warranty against manufacturing defects. (Vibe 60 days)
DIMENSIONS: Shaft 6 1/2″ x 1 3/8″; Bulb 3 1/2″ x 1 1/2″
Generic Care Information
BATTERY OPERATED VIBE CARE
VIBRATOR CARE
VIBRATOR TROUBLESHOOTING CARE
Owner's Manual
SILICONE VIBE ATTACHMENT
Vibrator must be removed from its silicone companion if you want to boil the silicone (3 to 4 minutes, stove top pot of water).
VIBE INCLUDED
The little bullet vibe included with your silicone toy is best thought of as a “gift with purchase” as it is not designed with a long life in mind.
This vibe will not stand up to frequent cleaning on its own so we don’t recommend you use it as a stand-alone toy.
The vibe runs on button cell batteries (included). The switch is sensitive enough to accidentally turn on the vibrator when brushing across it (you also have to be sure that you’ve fully turned it off as its lowest setting is very subtle). After we check the operation of each unit, we install the batteries and stick a tiny paper or plastic “dot” on the end of one of the batteries. This prevents the batteries from discharging during shipping. You’ll want to remove the “dot” to operate your vibe. We raise this so that you’re aware of proper vibe use to avoid running down and replacing batteries more often than you’d anticipated!
The vibe’s battery compartment may also have an essential plastic inner sleeve. The sleeve makes it easier to position the button cell batteries and holds the batteries in place. Keep the sleeve where you first find it so that your battery insertion instructions are right side up and operational. Finally, only tighten the vibe’s cap in increments by twisting the cap bit, by bit, to make sure you don’t tighten it too hard, too far, and without caution too fast. Twisting it vigorously and tightly may crack or break your cap.