Perk by Fuze – Owner’s Manual

It’s not too hard to see that the makers of Perk had stimulation for two in mind. Stimulation for the penetrator is delivered with each thrust via Perk’s atypical base, which dips lower and has a washboard texture on the backside. To note: it may require that the whole set up is worn a bit lower on the pubic mound (so the texture hits the right spot).

Perk’s shaft has a bouncy soft texture on the surface and a functional head to avoid pop outs. This toy is great for G-spot or prostate stimulation.

WARRANTY: Lifetime warranty against manufacturing defects.

DIMENSIONS: 6.25″ x 1.25″

MORE ON HOW TO CHOOSE: DILDOS

GENERIC CARE INSTRUCTIONS: SILICONE CARE

SPECIAL INSTRUCTIONS: Not compatible with silicone lubricants.

Vibrator must be removed from its silicone companion if you want to boil the silicone (3 to 4 minutes, stove top pot of water).

If you want to remove a vibrator from its silicone housing, we always recommend peeling back the silicone rather than pulling on the vibe. The silicone base is designed to peel back for vibe removal. Don’t tug the vibe out. A slight peeling (think: taking off a turtleneck sweater) is necessary to release the suction (in the hollow of the silicone base) from its snug fit and to avoid tearing your silicone.

The vibe-hollow in your silicone housing can develop quite the vacuum when plunking a vibe in-and-out, possibly damaging the vibe when you try to remove it. If you do want to put in and take out a vibe frequently, use the corner of a Ziploc bag to line the silicone housing so that you can easily extract the vibe by tugging on the bag liner. Otherwise, frequent vibe removal might eventually tear the silicone housing or damage the vibe.